Industrial Gate Safety Tips

1. Please ensure that the door is running well without any jamming; Only allow the installation of door openers on doors with balance springs and good balance, otherwise it may cause overloading and damage to the door openers; You must ask professional installation personnel to inspect and install during installation.
2. Installation and wiring must be carried out in accordance with building construction standards and electrical standards, with a wire diameter of ≥ 1.5mm2; The power cord must be connected to a grounded socket, and it is prohibited to remove the grounding lead from the power cord.
3. Mechanical limit devices or buffer boosters should be installed at the end of the door guide rail to prevent the door from sliding out.
4. The quick release handle is only for professional personnel to install and maintain the operation of the door body, and can only be used when the door body has been closed
Locks can only be released from this wrench when there is no risk of falling under their own weight. It is strictly prohibited to release this wrench during operation.
5. The control box should be installed in a place where the operation of the door can be observed, and it is prohibited to operate the remote control in a place where the operation of the door cannot be seen.
6. Please fix the control box on a wall pillar 1.4 meters above the ground to prevent children from accidentally touching it. Meanwhile, keep the remote control safe and prohibit children from touching or playing with it to prevent danger.